Rockbox mail archive

• Next message: Henrik Backe: "Re: F1 boot + ajbrec.ajz = ?"
• Previous message: anmelden: "Re: Create UCL out of the bleeding edge build - me wrote a program ;)"
• In reply to: Mike Holden: "Re: F1 boot + ajbrec.ajz = ?"
• Next in thread: Henrik Backe: "Re: F1 boot + ajbrec.ajz = ?"
• Reply: Henrik Backe: "Re: F1 boot + ajbrec.ajz = ?"
• Reply: Mike Holden: "Re: F1 boot + ajbrec.ajz = ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

"Mike Holden" <rockbox_at_mikeholden.uklinux.net> writes:

> so I was removing the different #ifdef paths, as they aren't needed any more.

Did you run the sources through "gcc -E"?

I was just wondering about the purpose of

    #ifdef HAVE_CHARGE_DETECT /* Recorder & FM */
                                 ^^^^^^^^

in the source recorder/icons.c.
              ^^^^^^^^

Unless there's something deliberately obfuscating going on, I'd say
this #ifdef is superfluous since it is always true in recorder sources.

> However, various changes in that area result in the battery display being
> very low numbers (like 4 or 7), instead of the actual value which is
> 85-100.

I would like to have an option to display the raw battery voltage
'cause sometimes I think it would provide better information than the
highly processed percentage value (i.e., when trying to explain
strange readings).

-- Johan

• Next message: Henrik Backe: "Re: F1 boot + ajbrec.ajz = ?"
• Previous message: anmelden: "Re: Create UCL out of the bleeding edge build - me wrote a program ;)"
• In reply to: Mike Holden: "Re: F1 boot + ajbrec.ajz = ?"
• Next in thread: Henrik Backe: "Re: F1 boot + ajbrec.ajz = ?"
• Reply: Henrik Backe: "Re: F1 boot + ajbrec.ajz = ?"
• Reply: Mike Holden: "Re: F1 boot + ajbrec.ajz = ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]