Rockbox.org home
release
dev builds
extras
themes manual
wiki
device status forums
mailing lists
IRC bugs
patches
dev guide



Rockbox mail archive

Subject: Re: USB + A7V333 = reboot?
From: Minuk Choi (Choi.Minuk_at_verizon.net)
Date: 2003-10-02


I read the instruction manual for the A7V333 when I hooked up the front USB.
There are 2 sets of USB pins. The one towards the back is labeled as USB
2.0, while those that are in the lower right side(toward the front) are
labled as USB1.1 header

----- Original Message -----
From: "planet77" <planet77_at_gmx.net>
To: <rockbox_at_cool.haxx.se>
Sent: Wednesday, October 01, 2003 11:30 AM
Subject: Re: USB + A7V333 = reboot?

> Hi!
> I also have the A7V333 Board, which is very good, but I have to go and
plug
> the cable in the port behind of my tower for USB 2.0
> My USB Ports on the front of the tower are only USB1.1. But like Linus
said,
> I will by a USB-Hub someday, too.
> But I never had to reboot. I plug it into a certain USB Port on the back
and
> everything works fine.
>
> Fred
>
>
> ----- Original Message -----
> From: "Linus Nielsen Feltzing" <linus_at_haxx.se>
> To: <rockbox_at_cool.haxx.se>
> Sent: Monday, September 29, 2003 10:03 AM
> Subject: Re: USB + A7V333 = reboot?
>
>
> > Minuk Choi wrote:
> > > And once it is plugged in, the wire is too short and the unit would
> > > have to be on the floor or on top of the tower, instead of on my lap
> > > or somewhere where I can keep an eye on it.
> >
> > You could always invest in a USB 2.0 hub.
> >
> > Linus
> >
>



Page was last modified "Jan 10 2012" The Rockbox Crew
aaa