Rockbox.org home
release
dev builds
extras
themes manual
wiki
device status forums
mailing lists
IRC bugs
patches
dev guide



Rockbox mail archive

Subject: Re: ROLO automatically after *Panic?
From: Tom Evans (tom_at_impulsed.net)
Date: 2003-10-07


Maybe, the only panic messages I encounter are when the OS is not in a
fit state to continue (usually my own fault). Perhaps an equally good
solution would be to automagically reboot, and therefore reinitialise
the hardware.

Regards

Tom

Dave Jones wrote:

> I'm investigating ways to make the AJBR20 an extremely reliable
> long-term recorder.
>
> Would it be a bad idea to add some code to panic.c such that the panic
> message was logged to a file and then Rockbox was reloaded via Rolo
> and rolo_load? Is this even possible? I suppose it would be impossible
> to log a panic message to a file if there were a disk error, since I
> assume memory is cleared during the Rolo process, though I could be
> wrong.
>
> What I'd like is to set up my Rockbox so that as soon as it was turned
> on it would start recording. Then if any errors were encountered
> during recording, it would Rolo, forcing a restart of the firmware and
> thus start recording again. It's pretty straight forward to set
> Rockbox up to start recording right after startup, but is it a really
> bad idea to Rolo after a panic message?
>
>
> Thanks for any thoughts,
>
>
> Dave
>
>
>
>
>
> _______________________
> Dave Jones P.E.
> Senior Project Engineer
> HFP Acoustical Consultants Inc.
> 6001 Savoy Dr., Suite 115
> Houston, Texas 77036
> 713.789.9400 (phone)
> 713.789.5493 (fax)
> www.hfpacoustical.com
> _______________________



Page was last modified "Jan 10 2012" The Rockbox Crew
aaa