Rockbox mail archive

• Next message: Gary: "question about cleaning harddrive"
• Previous message: Markus Grebenstein: "Re: Schematics for JBS20 needed (ATA 44 pins)"
• In reply to: Markus Grebenstein: "Re: Schematics for JBS20 needed (ATA 44 pins)"
• Next in thread: Markus Grebenstein: "Re: Schematics for JBS20 needed (ATA 44 pins)"
• Reply: Markus Grebenstein: "Re: Schematics for JBS20 needed (ATA 44 pins)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Markus Grebenstein wrote:

> OK thanks. Do you know if the violtage on PIN 42 (Motor) and/or 41
> (Logic) should be 5V all the time, when teh processor is running?

On the newer Studio models, the hard drive power can be controlled by
the CPU, with port pin PB4. However, the firmware enables the HD power
early in the boot sequence and never turns it off again.

Linus

_______________________________________________
http://cool.haxx.se/mailman/listinfo/rockbox

• Next message: Gary: "question about cleaning harddrive"
• Previous message: Markus Grebenstein: "Re: Schematics for JBS20 needed (ATA 44 pins)"
• In reply to: Markus Grebenstein: "Re: Schematics for JBS20 needed (ATA 44 pins)"
• Next in thread: Markus Grebenstein: "Re: Schematics for JBS20 needed (ATA 44 pins)"
• Reply: Markus Grebenstein: "Re: Schematics for JBS20 needed (ATA 44 pins)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]