Rockbox mail archive

• Next message: Ronald Teune: "Re: ROMbox on the FM"
• Previous message: G. McFarlane: "Re: ROMbox on the FM"
• In reply to: Newbeewan: "Re: flashing my ajbr"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

or... if the cpu board of the old one is still correct, you can replace
your current board with the old one. That's way easier than soldering the
chip. Lee did this too, so he can tell it works :-)

Ronald

On Tue, 24 Aug 2004 18:02:42 +0200, Newbeewan <newbeewan_at_fr.st> wrote:

> It's out of my knowledge :(
> that's very bad luck....
> See you
>
> Lee Pilgrim a écrit :
>
>> Sorry, no. If you happen to be good at soldering, you could replacce
>> the flash chip with a good one.
>>
>> On Tue, 24 Aug 2004 16:47:18 +0200, Newbeewan <newbeewan_at_fr.st> wrote:
>>
>>> Hi,
>>> I just bought a new ajbr after the death of my old one.
>>> I want to flash it but in HW info, flash is : M=?? D=??
>>> Is it possible to flash it any way ?
>>> Thanks
>>>
>>> Mourad
>>>
>>> PS : my full [hw info] :
>>> ROM : 1.28
>>> Mask : 0x0302
>>> USB : positive
>>> ATA : 0x200, master
>>> PR : positive
>>> Flash : M=?? D=??
>>> ROM CRC : 0x222F V1
>>> _______________________________________________
>>> http://cool.haxx.se/mailman/listinfo/rockbox
>>>
>>>
>> _______________________________________________
>> http://cool.haxx.se/mailman/listinfo/rockbox
>>
>>
>
> _______________________________________________
> http://cool.haxx.se/mailman/listinfo/rockbox
>
_______________________________________________
http://cool.haxx.se/mailman/listinfo/rockbox

• Next message: Ronald Teune: "Re: ROMbox on the FM"
• Previous message: G. McFarlane: "Re: ROMbox on the FM"
• In reply to: Newbeewan: "Re: flashing my ajbr"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]