On Fri, Aug 26, 2005 at 09:14:32AM -0600, Rocker wrote:
> "Step 4: Install it on the iriver
> Just follow the normal Firmware Upgrade procedure. You should now have a
> boot loader that tries to load Rockbox from disk when you start the player."
> *What is the normal firmware upgrade procedure for IRiver?

First, the jukebox should be powered by the charger during the firmware
upgrade. Follow these steps:

Copy the patched file ihp_120.hex to the root of your player.

Now disconnect the device and start op the player.

Go into the menu (hold the joystick down for a few seconds).

(Note that the menu will disappear after a 20 seconds of inactivity.)

Go into the "General" menu (first item, so just press the joystick).

Go to the "Firmware Upgrade" menu option (Press the joystick down 5
times).

Press the joystick.

A dialog pops up asking you if you are sure - move the joystick to the
right and press the joystick to confirm and the firmware upgrade begins.

After a while, the player will turn off and the firmware upgrade will be
complete.

> What am I missing here? When I patched the firmware do I need to rename
> the resulting file?

No, the file should be named ihp_120.hex (or ihp_100.hex if you have a
H110 or H115 - 10 and 15gb models).

-- 
Jonas H
rasher(at)rasher(dot)dk
                                                  -- Random .sigs suck
_______________________________________________
http://cool.haxx.se/mailman/listinfo/rockbox