Hi Mike.

OK.

I've got a sighted friend to help me now.

We did the firmware upgrade now. It said, "Do not touch during firmware
upgrading", then powered off after about 40secs.

When I boot now and hit navi to go into the menu and arrow up and down,
still no speech

Plus I'm still getting the bleep when it boots..

The file I used was called, H300.hex

And I've got the daily build from Thursday, of rockbox

Cheers
Barry Toner

MSN/Email: djpaddy@djpaddy.co.uk
Mobile: 07921611253

"Hope is the destination that we seek.
Love is the road that leads to hope.
Courage is the motor that drives us.
We travel out of darkness into faith."
---The Book Of Counted Sorrows---
----- Original Message -----
From: "Michael DiFebbo" <medifebbo@rcn.com>
To: "Rockbox" <rockbox@cool.haxx.se>
Sent: Saturday, May 27, 2006 5:24 PM
Subject: Re: iRiver H340

> Dj Paddy wrote:
>> Hi.
>>
>> Yes I used the patcher to do this.
>>
>> I'll try again.
>> Barry Toner
>>
> I'm not sure that you understood my post. AFTER you use the fwpatcher to
> patch the iriver firmware with the Rockbox bootloader, you need to put the
> H300.hex file into the root of H300. You then need to boot into the
> iriver firmware, select "Upgrade firmware," and then select "Yes." You
> say "I used the patcher to do this," but this step doesn't have anything
> to do with the patcher.
>
> If you haven't yet performed this step, you should get sighted assistance
> if at all possible. When you select "yes" to upgrade the firmware, the
> display will indicate that the firmware is upgrading. This process takes
> about a minute, and then the player shuts off. However, there's no
> audible feedback to tell you when this happens, and it is critical not to
> inadvertently interrupt the upgrade process.
>
> I hope this helps.
>
>
>
> __________ NOD32 1.1562 (20060527) Information __________
>
> This message was checked by NOD32 antivirus system.
> http://www.eset.com
>
>
Received on Sat May 27 19:17:52 2006