Rockbox.org home
release
dev builds
extras
themes manual
wiki
device status forums
mailing lists
IRC bugs
patches
dev guide



Rockbox mail archive

Subject: Sansa E200 v1 radio theory.

Sansa E200 v1 radio theory.

From: GREG <rundarm_at_centurylink.net>
Date: Sun, 1 Apr 2012 19:22:33 -0400 (EDT)

In the past I had presets working on my Sansa E200 v1 radio. (V3.10) I booted under the original firmware copied the software over... did a defrag on it via defraggler while booted under original firmware . then booted rockbox.  Presets were there but radio wouldn't play. I looked in the debug... Radio hardware is seen. I did notice though that no matter what the station mono or stereo it didn't change. Station signal strength also remained the same. I changed the location to USA/Canada. The signal strength remains a constant 75.

Is it possible to reset the radio chip electronically since it is detected. Just an idea since the debug screen says it does exist. I did see this as a bug before hand that radio dissapears on sansa but thought providing the information I had may help. I also had removed a MSD from before hand. The presets were on the internal.

Comments?

Thank You,

Greg Manhart

rundarm_at_yahoo.com

P.S.

None of my posts are an April Fool's joke.
Received on 2012-04-02


Page was last modified "Jan 10 2012" The Rockbox Crew
aaa