release
dev builds
extras
themes manual
wiki
device status forums
mailing lists
IRC bugs
patches
dev guide



Search | Go
Wiki > Main > DisassemblePlayer

Disassembling the Archos

There are several ways to disassemble the Archos Jukeboxes. Here is an approach where you don't need to bend any metal parts.

This instruction also applies to the Archos Recorder V1. If you want to disassemble an Archos Recorder FM or V2, check out this page: http://www.angelfire.com/trek/archos/.

You need a Torx 10 screwdriver and a very small (~2mm) philips head screwdriver.

b10.jpg

First, remove the battery covers and unscrew all 8 visible screws: 2 torx screws on the left and right sides, and 2 philips head screws on the top and bottom. Then you simply lift off the plastic top cover.
b5.jpg b6.jpg

Use your thumb nails to compress the thin edge of the rubber while gently pulling the metal plate over it.
b7.jpg b8.jpg

Do the same on the side.
b9.jpg b11.jpg

You have now freed one end of the Archos. Now lift the blue rubber bumbers up from the circuit board on the other end, and simply slide the Archos out of its back plate.

Björn

r4 - 02 Apr 2021 - 20:46:06 - UnknownUser

Copyright © by the contributing authors.