Index: manual/getting_started/installation.tex
===================================================================
--- manual/getting_started/installation.tex	(revision 17725)
+++ manual/getting_started/installation.tex	(working copy)
@@ -92,10 +92,7 @@
 
 \begin{description}
 \item[USB connection.] To transfer Rockbox to your \dap{} you need to
-  connect it to your computer. To proceed you need to know where to access the
-  \dap{}. On Windows this means you need to figure out the drive letter
-  associated with the device. On Linux you need to know the mount point of
-  your \dap{}.
+  connect it to your computer in MSC mode (rather than MTP mode).
 
   \opt{ipod}{
     Your \dap{} should enter disk mode automatically when connected to a
@@ -112,16 +109,20 @@
     the moment. Please use USB only.} 
   }
 
-  \opt{sansa}{\warn{The following steps require you to change the setting in
-    \setting{Settings $\rightarrow$ USB Mode} to \setting{MSC} from within the
-    original firmware. Never extract files to your \dap{} while it is in
-    recovery mode.}}
+  \opt{sansa}{\warn{From within the original firmware, go to
+    \setting{Settings $\rightarrow$ USB Mode} and set it to \setting{MSC}.}}
   \opt{h10,h10_5gb}{\warn{The following steps require you to use UMS mode and so
     may require use of the UMS trick as described in the bootloader installation
     section.}}
   \opt{gigabeatf}{\warn{During installation, do not connect your \dap{}
     using the cradle but plug the USB cable directly to the \dap{}.}}  
 \end{description}
+
+Now connect your \dap{} to the computer. To proceed you will need to know where to access the
+  \dap{}. On Windows this means you need to figure out the drive letter
+  associated with the device. On Linux you need to know the mount point of
+  your \dap{}.
+
 For manual installation and customization additional software is required.
 \begin{description}
 \item[ZIP utility.]\index{zip}