MioC510 < Main

Downloads
release
dev builds
extras
themes
Documentation
manual
wiki
device status
Support
forums
mailing lists
IRC
Development
bugs
patches
dev guide
Donate
Wiki > Main > MioC510
---+!! Mio C510 / C710


%TOC%

---

---+ Overview
This is the page for the Mio C510 and C710 devices.

---+ Hardware

The Mio C510 and C710 are GPS/DPA devices running WinCE .NET 4.2. They features 4 hardware buttons (power, menu, volume up/down), a reset button, an on/off power switch and a touchscreen. They also features a speaker. The following chips can be found on the PCB:
   * W68136:3V SINGLE-CHANNEL 13-BIT LINEAR VOICE-BAND CODEC
   * VP1020-N: Voice Processor
   * WM8976: Stereo CODEC With Speaker Driver
   * LC4064ZC-75MN6: 3.3V/2.5V/1.8V In-System Programmable SuperFAST TM High Density PLDs
   * GSC3f-7879: SirF Star III
   * K4M561633G: DRAM
   * K9F4G08U0?: Flash
   * B6150H1: BRF6150 bluetooth v1.2 compliant
   * 922Z: ISL6292 Li-ion/Li Polymer Battery Charger 
   * 68TI: LTC3411EMS ?
   * 4855: FAN4855 500mA High Efficiency Boost Regulator with Adjustable Output, Shutdown and Low Battery Detect
   * S3C2440L-40: Samsung S3C2440 SoC
   * GNS GmbH: TMC receiver ? (only C710)

---+ Recovery mode

The Mio C510 and C710 feature a recovery mode accessible by hard powering down the device and then powering up holding the volume down button. It has several menus to update uboot or wince. The bootloader can be safely overwritten using the WinCE SD/MMC update. It is also possible to boot WinCE by holding menu and volume up.

---+ PCB Scans


---+ Pins

Here is a list of all the pins used by the OF.  Direction only applies to GPIO.
| *Pin* | *Dir*/*Function* | *Component*  | *Comment* |
| !GPA0 | ADDR0 | NAND | |
| !GPA1 | ADDR16 | NAND | |
| !GPA2 | ADDR17 | NAND | |
| !GPA3 | ADDR18 | NAND | |
| !GPA4 | ADDR19 | NAND | |
| !GPA5 | ADDR20 | NAND | |
| !GPA6 | ADDR21 | NAND | |
| !GPA7 | ADDR22 | NAND | |
| !GPA8 | ADDR23 | NAND | |
| !GPA9 | ADDR24 | NAND | |
| !GPA10 | ADDR25 | NAND | |
| !GPA11 | ADDR26 | NAND | |
| !GPA12 | nGCS[1] | NAND | |
| !GPA13 | nGCS[2] | NAND | |
| !GPA14 | nGCS[3] | NAND | |
| !GPA15 | nGCS[4] | NAND | |
| !GPA16 | nGCS[5] | NAND | |
| !GPA17 | CLE | NAND | |
| !GPA18 | ALE | NAND | |
| !GPA19 | nFWE | NAND | |
| !GPA20 | nFRE | NAND | |
| !GPA21 | nRSTOUT | NAND | |
| !GPA22 | nFCE | NAND | |
| !GPB0 | TOUT0 | Video | Backlight |
| !GPB9 | output | Battery | |
| !GPB10 | output | Codec | |
| !GPC1 | VCLK | Video | |
| !GPC2 | VLINE | Video | |
| !GPC3 | VFRAME | Video | |
| !GPC4 | VM | Video | |
| !GPC8 | output | Video | |
| !GPC9 | output | BTHCI | Chip Enable / Reset |
| !GPC11 | VD[3] | Video | |
| !GPC12 | VD[4] | Video | |
| !GPC13 | VD[5] | Video | |
| !GPC14 | VD[6] | Video | |
| !GPD2 | VD[10] | Video | |
| !GPD3 | VD[11] | Video | |
| !GPD4 | VD[12] | Video | |
| !GPD5 | VD[13] | Video | |
| !GPD6 | VD[14] | Video | |
| !GPD7 | VD[15] | Video | |
| !GPD11 | VD[19] | Video | |
| !GPD12 | VD[20] | Video | |
| !GPD13 | VD[21] | Video | |
| !GPD14 | VD[22] | Video | |
| !GPD15 | VD[23] | Video | |
| !GPE0 | I2SLRCK | Codec | |
| !GPE1 | I2SSCLK | Codec | |
| !GPE2 | CDCLK | Codec | |
| !GPE3 | I2SDI | Codec | |
| !GPE4 | I2SDO | Codec | |
| !GPE5 | SDCLK | SD | |
| !GPE6 | SDCMD | SD | |
| !GPE7 | SDDAT0 | SD | |
| !GPE8 | SDDAT1 | SD | |
| !GPE9 | SDDAT2 | SD | |
| !GPE10 | SDDAT3 | SD | |
| !GPE12 | input |  | Jack detect |
| !GPE14 | IICSCL | Codec | |
| !GPE15 | IICSDA | Codec |  |
| !GPF0 | input / EINT[0] | Button | Power button |
| !GPF2 | input / EINT[2] | Button | Reset button |
| !GPF4 | output | Codec | |
| !GPF7 | input / EINT[7] | SD  | SD detect |
| !GPG0 | output | SD | |
| !GPG1 | input | Battery | USB present |
| !GPG2 | output | BTHCI | Chip Enable |
| !GPG3 | input |  | Menu key |
| !GPG4 | input |  | Volume plus key |
| !GPG5 | input |  | Volume down key |
| !GPG8 | input | Battery | USB present (bis) ? |
| !GPG9 | input | Battery | Battery charging ? |
| !GPG10 | input | Battery | |
| !GPG11 | output | Battery / Video | Charging led color / LCD panel type detection ? |
| !GPH0 | nCTS0 | BTSer | UART[0] CTS |
| !GPH1 | nRTS0 | BTSer | UART[0] RTS |
| !GPH2 | TXD[0] | BTSer | UART[0] TX |
| !GPH3 | RXD[0] | BTSer | UART[0] RX |
| !GPH4 | TXD[1] | GPS | UART[1] TX |
| !GPH5 | RDX[1] | GPS | UART[1] TX|
| !GPH6 | output | BTSer | UART[0] DTR |
| !GPH7 | input? | BTSer | UART[0] DSR |
| !GPH10 | CLKOUT1 | BTHCI | External clock |
| !GPJ0 | output | GPS | |
| !GPJ2 | output | Video | |
| !GPJ3 | output | Video | |
| !GPJ5 | output | Video | |
| !GPJ6 | output | Codec | |
| !GPJ7 | output | GPS | Chip Enable/Power ?|
| !GPJ8 | output | GPS | |
| !GPJ9 | output | USB | connect / disconnect |
| !GPJ10 | output | GPS | |
| !GPJ11 | output | Codec | |
| !GPJ12 | output | GPS | | 

-- Main.AmauryPouly - 21 Jun 2012
r4 - 22 Jun 2012 - 09:17:36 - AmauryPouly