release
dev builds
extras
themes manual
wiki
device status forums
mailing lists
IRC bugs
patches
dev guide



Wiki > Main > DisassemblePlayer2 (compare)

Difference: DisassemblePlayer2 (r2 vs. r1)

Part 2: Taking the electronics apart

First, disassemble the Archos.

a2.jpga2.jpg

Locate the three solder points (yellow circles) where the top board is soldered to the frame.

On some units the there are also two additional solder points (green circles) where the top board is soldered to the "MP3REAR" board.

On newer units, there might be two additional points where the top board is soldered to the frame (orange circles). This was the case with my Studio 10 -- JensArnold


a3.jpga3.jpg

Remove the solder from these points.


a4.jpga4.jpg

Now carefully lift the top board...


a5.jpga5.jpg

...while pushing down on the CPU board below it.

The CPU board is connected with a 40-pin connector, that you have to disconnect by carefully pushing it down on both sides Use a semi-soft rounded plastic tool. DO NOT USE A SCREWDRIVER! There are delicate traces on the CPU board that you DON'T want to damage!


a6.jpga6.jpg

Ah, there. The top board is separated from the bottom (CPU) board and folded out to the side.

The CPU board can now be removed by carefully pulling it off its' connector to the MP3REAR? board.

Most likely, your unit will have less patch wires than this and might have a different set of power components on the left. That's because this is a Really Old Model™, made back in the 20th century (week 44, 2000) smile


Björn

r2 - 22 Sep 2005 - 06:24:30 - LinusNielsenFeltzing

Revision r2 - 22 Sep 2005 - 06:24 - LinusNielsenFeltzing
Revision r1 - 19 Sep 2005 - 23:26 - JonasHaeggqvist
Copyright by the contributing authors.