Wiki > Main > IPodNano2GPort (compare)
Difference: IPodNano2GPort (r36 vs. r35)
Rockbox currently can now boot and run on the 2nd generation iPod nano. This includes a read/write NAND (disk) driver and working plugins. Most features work, see the list below for things that are still missing.
A manual Rockbox installation consists of two parts - installing the Rockbox bootloader to your ipod, and installing Rockbox itself. The Rockbox bootloader is installed by running the ipodpatcher tool, and just needs to be done once. After you've done this, you can still use the Apple firmware by turning on the hold switch or holding the menu button when powering on your Nano.
Rockbox itself is installed by downloading http://build.rockbox.org/data/rockbox-ipodnano2g.zip and extracting the contents to the root (i.e. top-level) of your ipod. This URL always points to the most recent "current build" of Rockbox, updated automatically a few minutes after every change to the Rockbox source code.
Installing the 2nd Generation Nano is also supported by RockboxUtility, Rockbox's graphical installer. This is usually the simplest way to install Rockbox and does not require to run other tools or download the build manually -- the steps outlined above are done automatically. The Rockbox manual has full installation instructions.
In mid-2009, a vulnerability in the iPod's original firmware was discovered in its "Notes" application. This was exploited and used to dump the Boot ROM from within the Samsung SOC. This then allowed decrypting and dumping of the contents of the NOR flash (containing the iPod's bootloader, disk mode and diagnostic mode), which in turn allowed the encryption of the main firmware partition to be understood.
It is now possible to encrypt (using the AES hardware crypto unit inside the Samsung SoC) a bootloader and install it onto an iPod Nano 2G's firmware partition using ipodpatcher. Bootloader binaries are encrypted on an ipod using the crypt_firmware viewer plugin.
As of Rockbox 3.7 (November 2010), the iPod Nano 2G is considered a stable target.
The following is a list of known bugs in the Nano 2G port:
The following table shows the current status in Rockbox SVN of the various drivers required to be implemented before Rockbox is fully functional on the 2nd gen Nano.
(table needs to be reinserted)
r38 - 12 Dec 2010 - 15:32:52 - AndreeBuschmannRevision r36 - 02 Nov 2010 - 16:12 - SamuelKatz
Revision r35 - 02 Nov 2010 - 13:59 - MichaelSparmann
Copyright © by the contributing authors.