release
dev builds
extras
themes manual
wiki
device status forums
mailing lists
IRC bugs
patches
dev guide



Wiki > Main > SansaC200Erase (compare)

Difference: SansaC200Erase (r4 vs. r3)

Sansa C200 Erase

Introduction

This page describes a Linux-only method for completely erasing the C200's disk. This is useful when the recovery instructions described on SansaE200Unbrick fail to recover your device.

Instructions

Note: Following these instructions will erase all data on your device . %W%

  • Put your C200 in manufacturing mode (the same mode used with e200tool) and then run e200tool with the correct .bin file, e.g. "sudo ./e200tool recover c240erase.bin" or "sudo ./e200tool recover c250erase.bin"
  • This uploads and runs some code on your C200. This can take 45 minutes or more. You should see progress information on the screen.
  • When the erase is complete, it will prompt you to press a button to shutdown. Do as you're told. You may need to release hold first.
  • In the original firmware, reformat the flash (Format is in the Settings menu)

r6 - 27 May 2010 - 01:49:50 - JustinHannigan

Revision r4 - 03 Nov 2008 - 14:25 - RobertMenes
Revision r3 - 02 Nov 2008 - 22:28 - MichaelChicoine
Copyright by the contributing authors.