Wiki > Main > SansaFuzePlusRescue (compare)
Difference: SansaFuzePlusRescue (r4 vs. r3)
This page summarize some information on rescue tools and procedures for the Sansa Fuze+ player.
DO NOT attempt this procedure without asking for some advise on IRC. This procedure is non trivial, it will require you to open your player and do unsafe operations. Most of the possible "brick" states of the Fuze+ can be recovered without this procedure and thus it should only be attempted when failure of the internal storage has been identified
Some early Fuze+ have suffered from an internal storage defect making them partly or completely unusable. While the internal storage cannot be recovered (as far as we know) , the following procedure will allow you to go on using rockbox on such device by launching it from a microSD card. It consists mostly in two steps:
This procedure will require that you build a custom version of the bootloader and rockbox. Indeed normal version will try to make use of the internal storage. The patches required can be found here: g#567
Modifying the EEPROM is the tricky step. Indeed this this EEPROM is easily accessible from the i2c bus of the device but it is write protected by default. However the write protected pin is not heavily grounded which makes it possible to disable the protection on a temporary fashion. So the procedure will look like this:
You need to create 2 partitions on the microSD card:
You can use gparted to created those two partitions. The bootloader partition can be of any filesystem's type as we will reset it afterward (although setting some different filesystem from FAT32 can help you to identify it on the card.)
Then from a console as root launch fdisk on the microSD device:
where sdX is the name of the MicroSD? device (typically X is to be remplace by a letter, sdc for instance) Be sure to identify clearly that letter as a mistake can make some of your other partition unusable.
If you already know how to compile you can apply this patch and compile your own bootlooader/directory: bootloader/directory: g#567 Otherwise you can get a precompiled bootloader here Note that the precompiled bootloader might be old and/or buggy and thus is unsupported.
Note that the precompiled bootloader/directory might be old and/or buggy and thus is unsupported.
You can copy the bootloader to microSD partition with the following command
dd if=firmware.sb bs=512 seek=4 of=/dev/sdX$
where in sdX$, X is the same letter as above and $ the number of the bootloader partition on the microSD
It isn't very clear if this step is necessary, but if you still cannot start the bootloader you can add one last command:
dd if=/dev/zero bs=512 count=4 of=/dev/sdX$
where sdX$ stand as above
-- JeanLouisBiasini - 16 Aug 2013
r5 - 29 Dec 2013 - 13:36:05 - JeanLouisBiasiniRevision r4 - 01 Dec 2013 - 10:24 - JeanLouisBiasini
Revision r3 - 19 Aug 2013 - 11:54 - AmauryPouly
Copyright © by the contributing authors.