Rockbox.org home
release
dev builds
extras
themes manual
wiki
device status forums
mailing lists
IRC bugs
patches
dev guide



Rockbox mail archive

Subject: Problem - line in clipping when recording, signal way to high

Problem - line in clipping when recording, signal way to high

From: Meirion Williams [e-knowledge] <meirion_at_e-knowledge.net>
Date: Thu, 15 May 2003 18:49:27 +0100

Hi there,

I recently found the Rockbox site and must say you guys have done some
fantastic work here.

Puts Archos' software effort to shame!


I have a problem when recording from a lot of line-in analogue sources. I'm
recording from mixers in clubs, using TAPE-OUT or REC-OUT, and a phono to
3.5mm jack.

A lot of the time I can't turn the gain on the Rockbox down far enough to
record properly, the input is way to high and clips a lot or all of the
time, resulting in a useless recording.

I can turn the gain down to -3db, is that as low as it will go?

Is there any way I can get it lower, or is this a hardware restriction? Does
anyone know if the Archos software goes lower, as this is the sole reason I
bought a JBR, and if I can't make these recordings I'm stuffed :(

Unfortunately I can't really make any adjustments on the mixer(s) because
when the DJ is using them they will just turn the volume back up!


Thanks for anyone's help,

Meza
Received on 2003-05-15

Page template was last modified "Tue Sep 7 00:00:02 2021" The Rockbox Crew -- Privacy Policy