From: <Matthias.Klumpp_at_gmx.de>
Date: Thu, 13 May 2004 20:00:48 +0200 (MEST)

Well, discussion about remote control is currently very active, hein....

For first I currently did some work on that basic remote commands as they
are defined in SERIAL.C

All that works very fine with my JB Studio, so I assume that baud rate and
commands are absolutely correct.

A friend of mine bought a used JB Recorder the last days, so I was hungry to
test that remote control with it.

Being absolutely sure it will work immediately, I was made disapointed this
morning, when performing the test - happened NOTHING ????

I did not find any #define in the SERIAL.C related to JB models.

Anybody could tell me, if there are differences in the remote control of
different JB models ?

Otherwise I suppose the serial interface of his JBR might be broken :-((

THX

Matthias

-- 
----------------------------------------------------------------------
Sent by: Matthias Klumpp
E-Mail : Matthias.Klumpp_at_gmx.de
----------------------------------------------------------------------
ACHTUNG  : Diese E-Mailbox wird nur einmal wöchentlich gelesen !
ATTENTION: This E-Mail account is read only once a week !
ATENCAO  : Este box e-mail será lido apenas uma vez por semana !
----------------------------------------------------------------------
NEU : GMX Internet.FreeDSL
Ab sofort DSL-Tarif ohne Grundgebühr: http://www.gmx.net/dsl
_______________________________________________
http://cool.haxx.se/mailman/listinfo/rockbox

Received on 2004-05-13