From: Rocker <rocker_at_shaw.ca>
Date: Fri, 26 Aug 2005 09:14:32 -0600

Hi Jonas you wrote:

Basically it goes like this:

1. Patch a firmware using fwpatcher or the commandline tools.
done
2. Flash that firmware with the iriver firmware upgrade process.
wickie
"Step 4: Install it on the iriver
Just follow the normal Firmware Upgrade procedure. You should now have a
boot loader that tries to load Rockbox from disk when you start the player."
*What is the normal firmware upgrade procedure for IRiver?

3. Install daily/bleeding edge build onto harddisk.
done

What am I missing here? When I patched the firmware do I need to rename the
resulting file?

Cheers...rocker


----- Original Message -----
From: "Jonas H." <rasher_at_rasher.dk>
To: "Rockbox development" <rockbox_at_cool.haxx.se>
Sent: Friday, August 26, 2005 8:59 AM
Subject: Re: flashing IRiver


> On Fri, Aug 26, 2005 at 08:49:29AM -0600, Rocker wrote:
>> Hello,
>>
>> I patched the boot loader and copied it to my IHP 140
>>
>> I downloaded and installed the correct latest daily build.
>>
>> When I turned on the player the Iriver firmware loaded.
>>
>> Do I need to flash the player using the same flashing instructions that
>> are
>> in place for flashing the Archos?
>>
>> A few step by step instructions would be greatly appreciated.
>
> http://www.rockbox.org/twiki/bin/view/Main/QuickStart covers it.
>
> Basically it goes like this:
>
> 1. Patch a firmware using fwpatcher or the commandline tools.
> 2. Flash that firmware with the iriver firmware upgrade process.
> 3. Install daily/bleeding edge build onto harddisk.
> 4. Go Rockbox!
>
> --
> Jonas H
> rasher(at)rasher(dot)dk
> -- Random .sigs suck
> _______________________________________________
> http://cool.haxx.se/mailman/listinfo/rockbox
>

_______________________________________________
http://cool.haxx.se/mailman/listinfo/rockbox
Received on 2005-08-26