OKAY, OKAY...... as I know none has been able to sleep because doesn't
know whether I manage to do the update or not, I shall let you
know............... B-)))

Followed the instructions to do the flash update, and it worked
flawlessly ;-) I first used the old flash I had, gave me the warning
about old loader, but worked OK. Then I found the new flash files on
the blind page, and uploaded that version, to finally run the .ucl
again; it now boots into the 2.5 version in just two or three
seconds........... ;-)))

I now need to look for that small chip I bought to so the memory
upgrade........ I wonder whther I still have it or not........ I guess
not, and will have to buy one from one of you guys....... :-p

Cheers,

MO

On 2/15/06, Matias Orchard <matias.orchard@gmail.com> wrote:
> Hi there,
>
> I hope anyone can help me here..... I have (what I think and looks
> like) a flashed CVS 0406 Rockbox, and want to update it to what you
> have today....... I've used the Windows installer, and 'Info' keeps
> showing CVS 040624 version.
>
> Can someone send me to the right place?? The documentation on how to
> flash it is not well linked on the documentation section of the
> website........
>
> Any other tip would be gratly appreciated.
>
>
> Regards,
>
> MO
>
> On 2/14/06, Matias Orchard <matias.orchard@gmail.com> wrote:
> > Guys,
> >
> > Many thanks for your prompt replies. I kept reading after sending the
> > original message, and this is what happened.
> >
> > I first try with alkaline batteries (I knew the risk, but well...),
> > did everything as explained on your website, until I found a line that
> > made me recall about the 'F1' key when booting B-))) So, I tried that,
> > and did not do much....... went to Archos original boot screen, and
> > then froze. But! then I put back the original batteries, which were
> > almost dead, press 'F1', and then connected the charger.... went back
> > to the Archos charging screen.......... let it there
> > overnight............. and voila! I have my Rockbox back again this
> > morning!!!!!!!
> >
> > :-D
> >
> > New batteries are n the way, so I don't need to worry about that....
> > but the one (I believe!) thing I need to do now, is renewing my
> > Rockbox installation. I copied all the files (thru the Windows
> > installer), but the version I have - flashed, I think - is the CVS
> > 040624. How am I supposed to take it to the latest version???
> >
> > 1. Should I upgrade the firmware? How?
> > 2. Should I go back to Archos firmware, and only use hard drive installation?
> >
> > I thank you again, and look forward to your comments.
> >
> >
> > Cheers,
> >
> > MO
> >
> > ps: sorry for the empty subject, my bad ;-)
> >
> > On 2/14/06, Linus Nielsen Feltzing <linus@haxx.se> wrote:
> > > Matias Orchard wrote:
> > > > What do I need to do with my hard drive, before trying to turn on my
> > > > Rockbox?Huh I mean, I guess the problem is that all the Rockbox files
> > > > were deleted, and thus I need to reset the hard drive before using it
> > > > as the Rockbox drive........ Would you please help me here???
> > >
> > > The ATA: -1 message means that Rockbox was unable to communicate with
> > > the hard drive. This often means that the hard drive id dead, but it
> > > just as often means that the batteries are bad, or even the battery
> > > connectors.
> > >
> > > Try with a fresh set of batteries. If that doesn't work, see if you can
> > > fix the battery connectors. http://www.rockbox.org/docs/repairbattery.html
> > >
> > > If it still fails, try with another hard drive.
> > >
> > > Good luck!
> > >
> > > Linus
> > >
> > >
> >
> >
> > --
> > Matías Orchard
> > email matias.orchard@gmail.com
> > cell +56 9128-7843
> >
>
>
> --
> Matías Orchard
> email matias.orchard@gmail.com
> cell +56 9128-7843
>

--
Matías Orchard
email matias.orchard@gmail.com
cell  +56 9128-7843