From: Shiner <dodgy-curry_at_ntlworld.com>
Date: Wed, 25 Jun 2014 19:22:28 +0100

----- Original Message -----
From: "Roger" <rogerx.oss_at_gmail.com>
To: <rockbox_at_cool.haxx.se>
Sent: Wednesday, June 25, 2014 4:47 PM
Subject: Re: iriver h10 install problem


> Just FYI. Every time I would get such a message with any such destination
> device, the error was usually caused by the destination device being write
> protected or write permissions were not given.
>
> As such, make sure you perform these tasks as root or with system
> administrator
> privileges, and double check write operations are really being performed
> by
> also checking the time/date stamps on the destination files.
>
> So, just an FYI to make sure you're checking the time stamps! So many
> times,
> I've been caught by this simple error of not having written anything to
> the
> device.
>
> If files are being written, then I'm stumped.
>

Hi Roger

I had just formatted <again> and used the iriver recovery tool. I tried *US*
but it won't work, so I reverted to *Europe*. It now works OK as an *iriver*
pl layer.
This is it's current state ATM.

There are four folders within.
*Properties* gives the date as 12/01/2004 12:54

Althouuugh I am showing *Hidden Files* I can see no files within.

As far as I am aware... I am Sole user and administrator. I don't know how
to verify this though.

FWIW I only get the error message _after_ installing RB. I have to restore
to the above condition before I can get it working, nut it's useless to be
as I can't see it....which is why I need RB working.

Rog



-------------------------------------------------------------------
Unsubscribe: http://cool.haxx.se/cgi-bin/mailman/listinfo/rockbox
FAQ: http://www.rockbox.org/twiki/bin/view/Main/GeneralFAQ
Etiquette: http://www.rockbox.org/mail/etiquette.html
Received on 2014-06-25