Logik Dax code in SVN to the ATMT with tcctool works just fine, the lcd works and buttons can be read out. Furthermore, I uploaded the Logic Dax firmware with tcctool - it booted, and due to the connected USB and lack of NAND (removed to select USB boot mode) went straight to saying MTP connected. Logic Dax.
R G M1-RGB B 0YOOO1B-38-AO2
Differences with the Logic DaxI don't know if any of these are of any importance, but for completeness: DAB module is KSM-AEBP000S-800 6255 00-D-0PbF and not KSM-AEBP000S-800 6184 D-0PbF. It also does not appear to have an antenna. I'm not currently in a DAB Band III country so I can't test reception. Board version is 3306 instead of 2106 LCD is 0YOOO1B-38-AO2 and not 0YOOO1B-38-MO2 Flash is K9K8G08U0A? and not K9K8G08U0M?. Board version is 3506 cf. 1906.
Bus 005 Device 009: ID 140e:b021 Device Descriptor: bLength 18 bDescriptorType 1 bcdUSB 1.10 bDeviceClass 0 (Defined at Interface level) bDeviceSubClass 0 bDeviceProtocol 0 bMaxPacketSize0 64 idVendor 0x140e idProduct 0xb021 bcdDevice 1.00 iManufacturer 0 iProduct 0 iSerial 0 bNumConfigurations 1 Configuration Descriptor: bLength 9 bDescriptorType 2 wTotalLength 32 bNumInterfaces 1 bConfigurationValue 1 iConfiguration 0 bmAttributes 0xc0 Self Powered MaxPower 100mA Interface Descriptor: bLength 9 bDescriptorType 4 bInterfaceNumber 0 bAlternateSetting 0 bNumEndpoints 2 bInterfaceClass 255 Vendor Specific Class bInterfaceSubClass 255 Vendor Specific Subclass bInterfaceProtocol 255 Vendor Specific Protocol iInterface 0 Endpoint Descriptor: bLength 7 bDescriptorType 5 bEndpointAddress 0x82 EP 2 IN bmAttributes 2 Transfer Type Bulk Synch Type None Usage Type Data wMaxPacketSize 0x0040 1x 64 bytes bInterval 0 Endpoint Descriptor: bLength 7 bDescriptorType 5 bEndpointAddress 0x01 EP 1 OUT bmAttributes 2 Transfer Type Bulk Synch Type None Usage Type Data wMaxPacketSize 0x0040 1x 64 bytes bInterval 0 cannot read device status, Operation not permitted (1)
r4 - 14 Jun 2008 - 22:56:51 - AlexParker
Copyright © by the contributing authors.