dev builds
themes manual
device status forums
mailing lists
IRC bugs
dev guide

Search | Go
Wiki > Main > SanDisk > SansaE200Port > SansaE200Unbrick > SansaC200Erase

Sansa C200 Erase


This page describes a Linux- and Mac-only method for completely erasing the C200's disk. This is useful when the recovery instructions described on SansaE200Unbrick fail to recover your device.


Note: Following these instructions will erase all data on your device . ALERT!

  • Put your C200 in manufacturing mode (the same mode used with e200tool) and then run e200tool with the correct .bin file.
    • E.g.
      • sudo ./e200tool recover c240erase.bin
      • sudo ./e200tool recover c250erase.bin

  • This uploads and runs some code on your C200. This can take 45 minutes or more. You should see progress information on the screen.

  • When the erase is complete, it will prompt you to press a button to shutdown. Do as you're told. You may need to release hold first.

  • In the original firmware, reformat the flash (Format is in the Settings menu)

r7 - 02 Apr 2021 - 20:46:07 - UnknownUser

Copyright © by the contributing authors.